Electric Heater Warehouse


Your Number One Source For Electric Space Heaters

Please be aware that COVID-19 has caused supply chain disruptions that may delay the timely availability of various products sold on our websites.  We appreciate your patience and understanding and we are working hard to minimize the impact to our customers.  We thank you for your patronage and support during this difficult time.
Baseboard Heaters
Ceiling Heaters
Closeouts & Specials
Console Heaters
Convection Heaters
Corrosion-Resitant Heaters
Duct Heaters
Electric Snow Melting
Energy Efficient Wall Heaters
Explosion-Proof Heaters
Floor Heaters (Drop-In)
Floor / Pavement Heating
Garage and Shop Heaters
Industrial Heaters
Pipe Freeze Protection & Tracing
Popular Gas Heaters
Portable Heaters
Radiant & Infrared Heaters
Roof and Gutter De-Icing
Room Heaters
Scratch and Dent
Specialty Heaters
Toe Space Heaters
Underfloor Floor Heating
Unit Heaters
Ventilators and Fans
Wall Furnaces
Wall Heaters
Heat Loss Calculator
Wall Heater Selection Guide
King Electric
Mr. Heater

Secure Site Verified
Authorize.Net Merchant - Click to Verify

Home>Wall Heater Selection Guide>Register Style Heaters>QFG Series by Qmark

Qmark QFG2024T2M Open Coil Fast Heating Wall Heater With Blower and Thermostat - 240 Volts - 2000 Watts

Part Number QFG2024T2M
review 0 Review(s)
Qmark QFG2024T2M Open Coil Fast Heating Wall Heater With Blower and Thermostat - 240 Volts - 2000 Watts
Qmark QFG Series Wall Heater
Review this item Review this item
Manufacturer's List Price
Your Savings:
Your Price:
Availability May Vary, Dependent on Item
Additional discounting may be available on select items - Please call us at 800-472-3292!
Choose Options
Mounting Option
Recessed Mount - Std. Back Box Included
Surface Mounting Framer [+$34.89]

Qmark Marley Shallow Mount Electric Wall Heater


Qmark QFG Series Open Coil Fast Heating Electric Wall Heater


Wattages from 375 up to 2250 watts

Voltage choices include 120, 208 & 240 volts


Use as an Add On Heat Source In Large Rooms

or as a Primary Heat Supply In Smaller Rooms



  • Residential: QFG Series electric in-wall heaters are suitable for use in almost any room. Use single heaters in smaller rooms such as bedrooms and bathrooms. Use multiple heaters (controlled by a single thermostat) in larger rooms such as living rooms and family rooms. Wattage should be determined through heat loss calculations.

  • Commercial: Suitable as the primary heat source in smaller rooms and as supplemental heat in almost any general use area.


  • Dual Protection: Thermal cutout with indicator light and one time thermal fuse.

  • Tangential blower for whisper quiet operation.

  • Sienna White baked enamel finish.

  • Open coil element assures quick heat and low maintenance.

  • Three piece construction for ease of installation.

  • Permanently lubricated, dust protected bearings.

  • CLIP-N-FIT® feature Patented Clip-N-Fit® feature (US Patented No. 6,172,343) allows the installer to change the wattage of the heater to a lower output without moving jumper wire. Each heater is factory wired for its maximum wattage. To change wattage, clip out either jumper 1 or 2 as shown in the installation manual for desired wattage. This Patented Clip-N-Fit® feature also prevents the operator to change wattage after installation to a higher wattage.


  • Rough-in Dimensions: 14-3/8" L x 4-3/8" D x 6-5/8" H

  • Installed Dimensions: 16-7/8" L x 7-3/4" (Finished appearance)

  • Complete units feature back box, heater/blower assembly and integral thermostat. These models end in 'T2M'.

  • Please Note: Models ending in 'IF' feature heater/blower assembly and grille only. These are primarily used when replacing existing units. If a back box or thermostat is required, they may be purchased separately.