Qmark QTS Series Toe Space Heaters
Fits Where No Other Heater Will
Multiple Wattage - Three Piece Construction
Can be recessed into toe space areas under kitchen or utility room cabinets or into the soffit area above them. It can also be recessed into the risers of a stairway or under the vanity in the bathroom. It is convenient for checkout counters, ticket or toll booths and many other places where no other heater seems to fit.
Quick connections on wiring leads permit convenient means of changing outputs
Over temperature Protection - Comes equipped with an automatic over temperature protector that guards against overheating. Also standard is a pilot light that indicates the protector has operated. A thermal fuse provides a second level of over-temperature protection
Uniform Heating Of All Discharge Air - Heavy gauge steel fins are brazed to low watt density steel sheathed tubular heating elements in a uniform grid pattern. The grid covers the entire discharge area, resulting in uniform heating of all discharge air, lower operating temperature and prolonged element life
Quiet Operation - The tangential blower and the impedance protected, permanently lubricated motor provide trouble free, quiet operation.
Three Piece Construction - A separate back box, fan deck and front cover make installation simple and quick. The slide in fan deck locks into place without the use of fasteners, cutting down on installation time.
Models & Thermostat Options - The QTS1100, QTS1104, QTS1500 and QTS1504 models can be operated by either a built in or remote wall mounted, single pole line voltage thermostat (M601W or TH106). The QTS1500T and QTS1504T are provided with factory installed thermostats and do not require a wall mounted thermostat.
Six Models - Two models available for replacement installation where a wall thermostat was used and only two power wires were run into the old unit. These units are available in 120 volt or 240 /208 volt applications. Two other models with factory installed thermostats are available where higher wattage is required.
MOUNTING LIMITATIONS - Do not install heater behind towel rack, behind door, in floor, in closet, in ceiling, or where air flow may be obstructed.
Dimensional Details: Small Size - Back box is 14 1/8" wide x 8 7/8" deep x 3 1/2" high (will fit in the most narrow of applications). Front grille is 15 3/8" wide x 3 5/8" high.
QTS Specifications
QTS Installation Manual
QTS Installation Instructions - Addenda
Copyright Electricheaterwarehouse.com - F. N. Cuthbert Inc.. All Rights Reserved. eCommerce Software by 3dcart.
